Specifications

5.1.4: Telecontrol Call Procedure

The following procedure explains how to make a Telecontrol call. The conditions and

procedure differ when using PSTN or Cellular communication. For further information,

read sections 5.1.1, 5.1.2. and 5.1.3 above.

To make a Telecontrol call:

1. Call the control panel either using the double call method (PSTN) or

directly (Cellular); when the control panel picks up, two DTMF tones

are sounded.

2. Enter the Telecontrol code (Code 29) on your telephone within 15

seconds.

Do not enter your user code until you hear the two DTMF tones. Any digits entered before

the tones are sounded are disregarded by the system.

3. A DTMF tone is sounded to indicate that the system is ready to receive

commands.

The following DTMF commands are available:

x Press “2” for Two-Way Audio.

o If the TWA mode is defined as

“Simplex” (see 10.6.12: TWA Mode),

the audio channel opens in Listen

mode (microphone active/speaker

mute). To switch to Speak mode,

press “1” on your telephone. To

switch back to Listen mode, press “0”

on your telephone.

x Press “3” to fully arm the system.

x Press "4XX" to turn HA unit #XX ON

x Press "5XX" to turn HA unit #XX OFF

x Press “6” to disarm the system.

x Press “9” to cancel the siren.

The commands “3” (Full Arm),"4" (HA On), "5" (HA Off), “6” (Disarm) and “9” (Bell Cancel)

can also be executed at any time during a Two-Way Audio session.

4. The duration of the call is determined by the TC/VM Timeout (see

10.6.11: Telecontrol/Vocal Message Timeout). Ten seconds before the

timeout expires, two short DTMF tones are sounded. To extend the

call, press “7” on your telephone. This command restarts the timeout.

5. To disconnect before the end of the timeout, press “*” then “#” on your

telephone.

5.1.5: Arm/Disarm DTMF Commands

During a Telecontrol call, you can arm and disarm the system remotely using the DTMF

commands “3” (Arm) and “6” (Disarm). When arming the system in this way, the system

is armed immediately without an exit delay.

5.1.6. HA DTMF commands

During a Telecontrol call, you can turn On and Off the Home Automation units using the

DTMF commands “4XX” (HA unit #XX On) and “5XX” (HA unit #XX Off).