Specifications

4.7.11: Enable Programming

The Enable Programming command enables a user with Master code authorization to grant

access to system programming. This feature is relevant only if the Installer Access and/or the

RP Access options are programmed as “User Initiated” – see 9.14: Installer Access and

10.4.4: RP Access Options.

To grant access to the installer or remote programmer:

x From the Service menu, select Enable Prog. [711]; a 30-minute time

window is opened during which the Installer Code is valid or RP

communication may be established.

4.7.12: Global Chime

The Chime feature causes the control panel’s built-in siren to ring when specific zones

are triggered. Using the Global Chime option, you can enable or disable this feature for

all zones that are defined as Chime enabled – see 7.6.4: Chime.

To enable or disable Global Chime:

1. From the Service menu, select Global Chime [712].

2. Select either Enabled or Disabled.

3. Press 3 when the desired setting is displayed.

Though the Service menu is accessible to the Master and Installer only, Global Chime can

also be accessed via a convenient shortcut without needing to enter a valid user code. To

access the Global Chime option from Standby mode, press then.