Specifications

4.3: Sensor Bypassing/Unbypassing

When a sensor is bypassed, it is ignored by the system and does not generate an alarm

when triggered.

To bypass or unbypass a sensor:

1. From the Bypass Zones menu, select Bypass/Unbyp. [21].

2. Using the arrow keys, scroll to the sensor you want to bypass or

unbypass.

3. Press 3 to change the bypass status.

4. Press 2; Save Changes? is displayed.

5. Press 3 to confirm the changed bypass status.

To unbypass all sensors:

1. From the Bypass Zones menu, select Unbypass All [22].

2. Press 3; all sensors are unbypassed

All bypassed zones are automatically unbypassed when the system is disarmed.

A fire zone cannot be bypassed.

4.4: User Codes

The control panel supports up to 32 individual user codes. Each of these codes is four

digits long. Most system operations require you to enter a valid user code. The ability to

perform an operation is defined by your user code’s authorization level. These

authorization levels are pre-defined for each code as explained below.

Code 1: Master Code

The Master code is the highest user authorization level. With the Master code, you can

edit all other user codes except the Installer code, the Guard code and the Monitoring

station TWA Code. Additionally, the Master code grants access to the Event Log, the

Service menu and Home Automation Schedule programming. The Master code is a

“controlled” code. Arming and disarming using this code causes the panel to notify the

monitoring station with an Arm/Disarm event message

The default Master code is 1234. Change this code immediately after installing the

system!

Codes 2-19: Controlled Codes

When you use a controlled user code for arming and disarming, the panel notifies the

monitoring station with an Arm/Disarm event message.

Codes 20-25: Non-controlled Codes

Non-controlled codes do not cause the panel to send Arm/Disarm event messages to the

monitoring station. The panel sends a Disarm message only if you use this code to

disarm the system after an alarm occurrence.

Codes 26-27: Limited Codes

A Limited code enables the user to issue a code that is valid for one day only. This code

automatically expires 24 hours after it has been programmed. These codes are

“controlled” in that their use for Arm/Disarm is notified to the monitoring station.

Only if arm/disarm reporting is enabled during System Programming

ProGuard800™ -29-