Specifications

10. Mount the control panel to the wall using four screws and insert the back tamper

screw if required – see 2.3: Back Tamper.

The control panel shall be mounted so that it shall withstand a force of at least three times

its own weight.

11. Replace the Main Board and reconnect its peripheral modules.

12. Connect the flat cable connecting the Main board to the front panel keypad and

the replace the front cover’s fastening bands.

13. Apply AC power.

Always connect AC power before connecting the battery pack. Batteries are supplied

uncharged. When you first connect the battery, it is probable that the system will display a

Low Battery condition. Allow the battery to charge for at least 18 hours before use.

14. Connect the battery pack to the connector on the Main Board.

15. Position the front cover’s top holding hooks onto the back cover and snap the

front cover closed.

16. After installing the control panel, perform the Find Modules function – see 12.5:

Find Modules.

2.3: Back Tamper

The back tamper switch is an optional feature that provides an extra

safeguard in the event that the control panel is removed from the wall.

Figure 2.6: Perforated

Back Tamper Release

The back tamper switch is located on the rear side of the control

panel’s Main Board and is constantly depressed by the section of the

back cover shown in Figure 2.6.

For this feature to operate, you must insert a screw into the back tamper mounting hole –

see section 2.2.5: Step 5 – Installing the Control Panel and Transmitters. When the

control panel is removed from the wall, the screw causes the perforated section of the

plastic to break and remain attached to the wall. As a result, the back tamper switch is

released and an alarm is generated.

2.4: Installing HK855 Hardwire LCD Keypads

The system supports HK855 Hardwire LCD Keypads that may be installed up to 300m

from the control panel.

Flash Programming

Connector

LCD Contrast

Potentiometer

Terminal

Block

Tamper

Switch

Figure 2.7: HK855 Hardwire LCD Keypad (back cover off)

ProGuard800™ -17-