Specifications

7. Before permanently mounting the unit, test the acoustic sensor and the
transmitter from the exact mounting position. For further information on
testing the acoustic sensor, refer to the following section, Hand Clap
Test.
8. Knock out the required mounting holes on the back cover.
9. Mount the unit to the wall using the mounting screws provided.
10. Write the number of the zone on the sticker provided and affix the
sticker inside the front cover for future reference.
11. Close the front cover making sure that it snaps shut.
Hand Clap Test
The Hand Clap test enables you to test the GB843 while in Normal mode. This test
checks the sensors power supply, microphone and circuit board.
To perform a Hand Clap test
Clap your hands loudly under the sensor; the LED flashes twice but an alarm is not
generated.
ProGuard800™ -101-