Operation Manual

4 © MARMITEK
2. PACKAGE CONTENTS
MegaView 80 MegaView 81
1x transmitter (HDMI Transmitter) 1x transmitter (HDMI Transmitter)
1x receiver (HDMI Receiver) 1x receiver (HDMI Receiver)
2x Power adapter 1x Infrared receiver
1x User manual 1x Infrared blaster LED
2x Power adapter
1x User manual
3. CAT5e/CAT6 CABLE REQUIREMENTS
x UTP-, FTP- or STP-cable
x 24AWG or lower
x Solid twisted pair
x 100 ohm at 1MHz
x RJ-45 jack according to EIA/TIA T568B standard
Instead of CAT5e cable, CAT6 cable may also be applied (this offers better
quality). Use a ‘solid twisted pair CAT-5e or CAT-6 cable’ in order to
optimise transfer quality.
4. INSTALLATION
In order to check proper functioning of the system, it is advisable to test the
set-up first, using a short CAT-5e/6 cable.
1. Switch off all appliances before you start connecting.
2. Connect the HDMI source (Blu-ray disc player, TV Decoder, Media
Centre PC, etc.) to the MegaView 80/81 transmitter [1], using an HDMI
cable (not provided).
3. Connect the MegaView 80/81 receiver to the appliance shown [2] (e.g.
HDTV or projector), using an HDMI cable (not provided).
4. Use one CAT5e/6 Ethernet cable to connect the MegaView 80’s
transmitter to the receiver [3].