Operation Manual

4 © MARMITEK
3. CAT5e/CAT6 CABLE REQUIREMENTS
x UTP-, FTP- or STP-cable
x 24AWG or lower
x Solid twisted pair
x 100 ohm at 1MHz
x RJ-45 jack according to EIA/TIA T568B standard
Instead of CAT5e cable, CAT6 cable may also be applied (this offers better quality).
Use a ‘solid twisted pair CAT-5e or CAT-6 cable’ in order to optimise transfer quality.
4. INSTALLATION
In order to check proper functioning of the system, it is advisable to test the set-up
first, using a short CAT-5e/6 cable.
1. Switch off all appliances before you start connecting.
2. Connect the HDMI source (Blu-ray disc player, TV Decoder, Media Centre PC,
etc.) to the MegaView 65/66™ transmitter [1], using an HDMI cable (not
provided).
3. Connect the MegaView 65/66™ receiver to the appliance shown [2] (e.g. HDTV
or projector), using an HDMI cable (not provided).
4. Use one CAT5e/6 Ethernet cable to connect the MegaView 65/66™ transmitter
to the receiver [3].
Attention! The MegaView 65/66™ cannot be connected to an existing home network
(LAN), this may cause damage to the device.
5. Connect the power adapter [4] to the ‘5VDC’ connection on the MegaView
65/66™ and plug the adapter into a socket.
Attention! Do not place the MegaView 65/66™ transmitter or receiver in an
enclosed space, such as a TV cabinet or equivalent. Provide adequate ventilation to
ensure that the product is functioning properly and to protect against overheating.