Installation guide

4. Disable the ”

Enable Protected Mode” then press OK

3.3 Configuring the IP Address of the PC

If you failed to access to the camera, please check the IP address of

your computer. When you connect the camera to your computer

directly to proceed with configuration of the camera, you need to set

up the IP addresses to be in the same segment for the two devices

to communicate.

1. On your computer, click

Start > Control Panel to open the

Control Panel window.

2. Double-click

Network Connection to open the Network

Connection window.

3. Right-click

Local Area Connection and then click

Properties from the shortcut menu.

4. When the Local Area Connection Properties window appears,

select the

General tab.

5. Select

Internet Protocol [TCP/IP] and then click Properties

to bring up the Internet Protocol [TCP/IP] Properties window.

6. To configure a fixed IP address that is within the segment of the

camera, select the

Use the following IP address option.

Then, enter an IP address into the empty field. The suggested IP

address is 192.168.0.x (x is 1~254 except 30), and the

suggested Subnet mask is 255.255.255.0.

7. When you are finished, click

OK.