Installation guide

2.2 Connecting the Camera to LAN/WLAN
Use the provided Ethernet cable
to connect the camera to your
local area network (LAN).
When you connect the AC power
adapter, the camera is powered
on automatically. You can verify
the power status from the Power
LED on the front panel of the
camera.
Once connected, the Link LED
starts flashing green light and the
camera is on standby and ready
for use now.
If you use a wireless network in
your application environment, you
need to attach the included
external antenna to the camera.
When the camera is powered on,
the camera will automatically
search any access point with
“default” SSID.
Connecting the Ethernet Cable
IP Eye Anywhere
™ IP RoboCam ™
15
NOTE If the camera cannot to your wireless network, you need to
install the camera in LAN and proceed with WLAN settings.
Connecting the External Antenna