Installation guide

IP Eye Anywhere
- 41 -
 Factory Reset
Click Reset to restore all factory default settings for the camera.
 System Reboot
Click Reboot to restart the camera just like turning the device off
and on. The camera configuration will be retained after rebooting.
 Configuration
You can save your camera configuration as a backup file on your
computer. Whenever you want to resume the original settings, you
can restore them by retrieving the backup file.
- Backup: Click Get the backup file to save the current
configuration of the camera.
- Restore: Click Browse to locate the backup file and then click
Restore.
 Update Firmware
This item displays the current firmware version. You can upgrade
the firmware for your camera once you obtained a latest version of
firmware.
- Select the firmware: Click Browse to locate the backup file and
then click Update.
NOTE Make sure to keep the camera connected to the power
source during the process of upgrading firmware.
Otherwise, the camera might be damaged because of
failure of upgrading firmware.