Installation guide

IP Eye Anywhere
- 39 -
all weekdays to remove the selected time period from every
weekday. Click Delete to remove the selected time period.
- Start/End Time: Enter the start and end time and then click Add
to assign a time period within in the selected weekday.
Event Configuration >> Motion Detect Trigger
Select the Enable option to enable the trigger function of the camera,
so that you can send captured images within the detecting area to the
FTP server, or email receiver. You have to configure corresponding
settings, such as FTP server and email server, to enable this feature.
- Schedule Profile: Select a schedule profile from the pull-down
list.
- Action: Select the destination that the captured images will be
sent to: Send Email, or FTP Upload.
Event Configuration >> Schedule Trigger
You can separately configure the schedule for trigger function of the
Marmitek IP Eye Anywhere camera by Email, or FTP. Select the
Enable option on each item, and then select a Schedule Profile from
the pull-down list and set the Interval time.
With the IEA 20 and 21 you can also configure the schedule for trigger
function of the camera by Network Storage.
NOTE If the setting value of the Network Storage Recording Time
Per Event option in General Setting is longer than the Interval
time in Network Storage Schedule, the recorded file will be a
continuous video clip.
For example, if you set the Network Storage Recording Time
Per Event as 10 seconds and the Interval as 5 seconds,
recorded file becomes a non-stop video clip because the
camera will record a 10-second video clip every 5 seconds.