Installation guide

IPEyeAnywhere 241 / 341

4.8.3 Event Configuration >> Motion Detect Trigger

z Motion Detect Trigger: Select the Enable option to enable

the trigger function of the camera, so that you can send

captured images within the detecting area to the FTP server,

email receiver, or the Network Storage server, etc. You have

to configure corresponding settings, such as FTP server and

email server, to enable this feature. Please note that you

have to configure the related settings before enabling these

features.

- Schedule Profile: Select a schedule profile from the pull-

down list.

- Action: Select the destination that the captured images

will be sent to: Record to USB (Upload to YouTube),

Record to Network Storage, Send Email, FTP Upload,

Instant Message, or Upload Image to Picasa.

4.8.4 Event Configuration >> Schedule Trigger

You can separately configure the schedule for trigger function

of the camera by Email, FTP, or Network Storage. Select the

Enable option on each item, and then select a Schedule

Profile from the pull-down list and set the Interval time.

NOTE If the setting value of the Storage Recording Time Per

Event option in General Setting is longer than the Interval

time in Network Storage Schedule, the recorded file will be a

continuous video clip.

For example, if you set the Storage Recording Time Per

Event as 10 seconds and the Interval as 5 seconds,

recorded file becomes a non-stop video clip because the

camera will record a 10-second video clip every 5 seconds.