Operating instructions

entered in memory location 1. One short low
tone is given and the green indicator stops flash-
ing.
Repeat this procedure with the two other selected
telephone numbers by pressing 2 and 3 for placing
these in memory positions 2 and 3 respectively.
Note: All three numbers should be entered. You
may enter the same number more than once.
Call Identification:
If you select telephone numbers of people who’s
number has been entered by more than one Home
Guard, you can transmit an extra audible signal with
the pre-recorded message in order to identify the
Home Guard calling. The factory default is one
beep at the end of the message.
To change the number of beeps (1, 2 or 3):
1. Enter your PIN
2. Press 4 on the keyboard
3. Press 1, 2 or 3 for the required number of
identification beeps.
7. DELAY ARM
The alarm mode may be activated by either the
remote control or by the keyboard.
If the remote control is used, the Home Guard arms
and disarms instantly.
If you require a delay, in order to allow yourself to
leave or enter the room before arming or disarming
the Home Guard, you may set the Home Guard to
Delay Arm:
1. Enter your PIN (Personal Identification Number).
Factory default is [0000]: You will hear three
high tones and one low tone as confirmation.
The green indicator starts flashing.
2. Press 7 on the keyboard of the Home Guard:
One low tone is given for confirmation.
3. Press [ * ] for Delay Arm or # for Instant Arm:
One tone is given for confirmation and the indi-
cator stops flashing.
8. SIREN
Your Home Guard is equipped with a built-in siren.
This siren will frighten intruders so they’ll leave the
house.
If you require a so-called silent alarm (without siren),
you can change the factory default:
1. Enter your PIN (Personal Identification Number).
Factory default is [0000]: You will hear three
high tones and one low tone as confirmation.
The green indicator starts flashing.
2. Press 3 on the keyboard of the Home Guard:
One low tone is given for confirmation.
3. Press [ * ] for Siren On or # for Silent Alarm: One
tone is given for confirmation and the indicators
stops flashing.
9. PIN CODE SETTING:
Your Home Guard can be operated and pro-
grammed by using a so-called PIN code (Personal
Identification Number). The factory default code is:
[0000]. To avoid unauthorised use, enter your own
PIN code.
Note: Choose a code you will easily remember,
since the Home Guard will recognise this code only
for further operation.
1. Enter your PIN (Personal Identification Number).
Factory default is [0000]: You will hear three
high tones and one low tone as confirmation.
The green indicator starts flashing.
2. Press 5 on the keyboard of the Home Guard:
HOMEGUARD MS8000 5