Operating instructions

e. Do not mount the sensor on a metal surface or
next to electrical equipment such as TV sets or
computers.
Caution:
a. Radio equipment (e.g. wireless headphones or
loudspeakers) working on a frequency band of
433MHz will not create a false alarm, however,
these devices will limit the RF range of the
remote control considerably.
b. Pets, e.g. dogs or cats, may trigger the alarm,
and should therefore not be kept in the same
room as where the activated sensor is mounted.
5. REGISTERING REMOTE
CONTROLS (HANDSHAKE)
Home Guard can be remotely controlled by up to
4 radio remotes (1 piece KR10/1 supplied).
For security reasons, each remote selects a unique
code (1 out of 65.536) after the battery has been
installed.
Before using Home Guard, the base station has to
learn this specific code from each remote:
1. Enter your PIN (Personal Identification Number).
Factory default is [0000] see (9): You will hear
three high tones and one low tone as con-
firmation. The green indicator starts flashing.
2. Press 1 on the keyboard of the Home Guard:
One high tone is given for confirmation.
3. Press the ARM button on your remote: One low
tone is given for confirmation.
4. Repeat step 1-3 for a second up to fourth
remote if required.
5. Press any button on your Home Guard keyboard
to finalise the registration procedure: One short
low tone is given and the green indicator stops
flashing.
If no successive commands are entered within a
period of 15 seconds, the base station returns to
normal operation. To restart the registration you
start the procedure from step1.
6. PROGRAMMING OF
TELEPHONE NUMBERS.
You may select up to three telephone numbers to
be contacted if the alarm is triggered. These num-
bers may include mobile (GSM) numbers, however
you are not allowed to use national emergency
numbers from e.g. police, paramedical, etc.
The numbers you chose should be have well
informed people, instructed by you and able to help
in case of an alarm (e.g. neighbours, friends, rela-
tives or your own mobile).
To enter telephone numbers:
1. Enter your PIN (Personal Identification Number).
Factory default is [0000]: You will hear three
high tones and one low tone as confirmation.
The green indicator starts flashing.
2. Press 2 on the keyboard of the Home Guard:
One low tone is given for confirmation.
3. Press the [ * ] button: One high tone is given for
confirmation.
4. Enter the first telephone number you selected
(max. 16 digits). If a dialling pause is required
(e.g. with a certain type of PABX between 0 and
the number you want to dialled in order to
obtain an outside line) press another [ * ] for a
one second pause. One high tone is given for
confirmation of each number entered.
5. Press #: One high tone is given for confirmation.
6. Press 1 to place the telephone number you just
4 MARMITEK