Operating instructions

ManualsBrandsMarmitek ManualsHome building and DecorHOMEGUARD MS8000

2 MARMITEK

1. SAFETY PRECAUTIONS:

a. Home Guard is designed for indoor use only.

b. Use Home Guard only in dry places

c. The supplied power adapter is designed for use

for 230V only

d. Do not open the power adapter, as there is

dangerous voltage inside. No serviceable parts

are located inside.

e. In case of any need for service, contact your

nearest Marmitek Authorised Service Centre

(MASC).

f. The built -in siren generates an extremely high

noise level that may harm you if you are too

close! Never put your ears close to the Home

Guard.

2. IMPORTANT FUNCTIONS AND

CONTROLS:

1. Keyboard:

Open the cover by pulling the upper part forward.

2. Passive Infrared Sensor (PIR):

Detects motion within a range of 12 meters and an

opening angle of 110(.

3. Siren:

Built-in 90dB siren is triggered by an alarm and can

be switched of (silent alarm) via the keyboard after

entering your personal access code (PIN).

4. Battery compartment:

Contains a back-up battery in case of a power failure

or tampering. For longer back up times a 9V alka-

line (approx.10h) or Lithium battery (approx. 30h)

can be used.

Battery lifetime is reduced each time the power is

switched off or the power adapter is disconnected

from mains. If the Home Guard is disconnected

from mains for a longer period of time on purpose,

remove the battery first.

5. Status indicators:

6. Telephone input:

Connects the Home Guard to the public telephone

network with the supplied cable.

7. Power supply:

Only use the supplied 12V power adapter.

8. External alarm contact:

This input allows you to connect any external alarm

device with a non-powered NO (Normally Open) or

NC (Normally Closed) contact. E.g. smoke alarms,

magnetic door/window contacts, flood and temper-

ature detectors, etc.