SECURITY SET WITH BUILT-IN TELEPHONE DIALLER HOMEGUARD MS8000
1. SAFETY PRECAUTIONS: 3 2 5 1 7 a. Home Guard is designed for indoor use only. b. Use Home Guard only in dry places c. The supplied power adapter is designed for use for 230V only d. Do not open the power adapter, as there is dangerous voltage inside. No serviceable parts are located inside. e. In case of any need for service, contact your nearest Marmitek Authorised Service Centre (MASC). f.
You may connect multiple devices in series to the Home Guard. This allows you to turn your Home Guard into a complete security system with built-in telephone dialler. To connect any external security device, use the supplied cable with mini-plug or install an equivalent jack plug on these devices. 3. WIRELESS KEY FOB REMOTE CONTROL KR10/1 ARM: Will put the Home Guard into the armed position. The alarm is instant or delayed.
e. Do not mount the sensor on a metal surface or next to electrical equipment such as TV sets or computers. Caution: a. Radio equipment (e.g. wireless headphones or loudspeakers) working on a frequency band of 433MHz will not create a false alarm, however, these devices will limit the RF range of the remote control considerably. b. Pets, e.g. dogs or cats, may trigger the alarm, and should therefore not be kept in the same room as where the activated sensor is mounted. 5.
entered in memory location 1. One short low tone is given and the green indicator stops flashing. Repeat this procedure with the two other selected telephone numbers by pressing 2 and 3 for placing these in memory positions 2 and 3 respectively. Note: All three numbers should be entered. You may enter the same number more than once.
One low tone is given for confirmation. 3. Enter a new 4-digit PIN code: You will get three high tones and one low tone as confirmation and the indicator stops flashing. 10. DE-ACTIVATING THE BUILT-IN MOTION SENSOR: If you prefer to operate the Home Guard only by means of the external alarm contact rather than the built-in motion sensor, you can de-activate the PIR: 1. Enter your PIN (Personal Identification Number).
In case the confirmation is not received, the Home Guard will start dialling the second number and follow the same procedure. If the second person does not give confirmation, the third number will be dialled. 3. The telephone dialler does not dial out: Check that the telephone plug is connected properly Check that the telephone outlet is responding to a normal analog telephone. NOTE: Instruct the person who’s number has been entered to give the confirmation 0 just after the beep(s).
