User manual

4 © MARMITEK
3. OPERATION
Position the IPTV Coax Pro™ 1P-node where your internet and coaxial
cable enters the house. The 1P-node combines the two signals and
distributes them across your entire coaxial network. Position an IPTV Coax
Pro™ 4P-node at the location where you require a network connection to
connect your devices to the internet/IP. This allows you to easily add an
internet signal to your existing coaxial network, while maintaining your
coaxial signals.
Product features:
x Parameterized Quality of Service (PQoS): optimised for HD video
streaming by distinguishing between data traffic for video, voice and
gaming. When a large amount of data is being downloaded within the
network, for example, by a PC, your AV streams will not be
compromised and will be prioritised.
x Bandwidth reservation: provides a guaranteed bandwidth that is
required per connection and thus enables multiple simultaneous
connections.
x Low Latency: very low latency (<5ms) for the best online gaming
experience.
x LPF-1000 coaxial filter: set includes a Low Pass Filter that prevents
network signals from leaving your home (for safety) and increases the
impedance of your coaxial network (prevents signal loss).
x With built-in 4-port Ethernet Switch: simply connect up to 4 devices.
x Status Lights: visual display of the signal quality on the node facilitates
set-up and operation, without requiring any IP or networking
knowledge.
4. PREPARATION
The room in which you want to create a network connection (IP/internet)
must have a coaxial connection. This may be a wall outlet, splitter or the
end of a coaxial cable. Ensure that this coaxial connection has good signal
reception for analogue and/or digital television. If not, it may cause a poor
connection between the two IPTV Coax Pro™ nodes.