Operation Manual

14 MARMITEK
connected device is operated via your EasyControl 8 module (with RF signals). Use the
Marmitek Home Control TM13 module (available separately) and connect your table lamp
or other electrical appliance. Switch on/off: control everything with the EasyControl 8.
The Home Control TM13 module converts the RF signals of the EasyControl 8 into an X-
10 signal that is then transferred via the mains. All the other X-10 modules that are con-
nected to your mains, are also operated through the EasyControl 8 module. Read more
about this subject on the Marmitek web site www.marmitek.com
5. Troubleshooting
The remote control does not work or the codes are not stored.
• Check whether you have pressed the right Mode button for the device you want to
control.
• If the code does not work, you can try AutoSearch or enter the next code for your
brand.
• Check whether the batteries have been placed correctly.
• To program the remote control you need two (new) AAA-alkaline batteries.
• If the remote control has lost the code, you may have to replace the batteries.
• If the LED stays lit, you need to replace the batteries.
• Restore the remote control to its factory settings.
• On www.marmitek.com you will find a list of FAQ’s.
Returning the Easycontrol 8 to the original factory settings
• Keep the SETUP (9) button pressed until one of the Mode LEDs stays lit.
Release SETUP.
• Press STOP (21) twice and release the button.
• Press Mute (5) and release the button.
• The LED will extinguish after a few seconds.