Datasheet

Jon Waddington
33
The remote XBEE module is loaded with the router firmware. It samples the ADC pin and
transmits the sample to the receiving module. The sensor gives a linear voltage output
of 10mV/°C, meaning the temperature can be calculated using a simple equation.
The settings on the XBEE modules were entered using the X-CTU software. The table
below shows the relevant settings of the transmitter remote XBEE module. The
parameters in bold are unique to the module and cannot be edited.
Router
Description
ATID 3456
PAN ID address
ATSH 13A200
Serial number (high)
ATSL 40624DD8
Serial number (low)
ATDH 13A200
Destination address (high)
ATDL 403D8E44
Destination address (low)
ATD0 2
AD0 analogue input
ATIR FAO
Sample rate 4000ms
Figure 3.6.1.1. Schematic of the XBEE Transmitter