User manual

DoorPhone 150
7
ENGLISH
HANDSET
1. The supplied Li polymer battery pack is already installed in the
handset. (To replace, press down the lock button and slide open
the battery door, take out the battery pack and disconnect from the
socket
.)
2. With the handset remaining switched off, place it onto the charger
stand.
3. Plug in the supplied AC power supply into an AC outlet and connect
its output plug to the DC jack
located at the back of the charger
stand.
4. The charging indicator
should light up red during the charging
process. Adjust the position of the handset in the charger stand in
case this indicator does not light up. During charging, the battery
level icon
will show up in LCD and the segments inside the icon
will flash in turn.
5. The battery pack should be fully charged within 4 hours when used
for the first time. The icon
will disappear or remain visible in LCD
if the unit is switched on.
TO AC OUTLET