User guide

6
Programming
Programming options
Specifying a device code
The simplest way to set up the MSR+ to control
another product is to enter the appropriate device
code for the product. A complete list of device codes
for each of the supported products is given at the
back of this manual.
Entering a device code erases any learnt commands
for that source key.
To specify a device code
Press the source key you want to use for the
product; for example, TV.
Hold down 0 and Mute simultaneously for two
seconds until the indicator flashes twice and stays
lit.
Enter the appropriate device code on the numeric
keypad.
For example, if your TV is a JVC enter 0051.
If you entered a valid device code the indicator will
turn off and your MSR+ is ready to control the other
product. If you entered an incorrect code, or pressed
an invalid key, the indicator will flash six times and
programming is abandoned.
•
•
•
For some products more than one device code is
listed. Try each of the alternative device codes in turn
until you find the one that controls your product.
To reset the source key to control Meridian products
enter the device code 8888.
Auto-programming
This procedure lets you step through the library of
remote controls in the MSR+ until you find the one
that switches your product to standby. This is likely to
be the correct one for your product.
To auto-program
Make sure your other product is switched on and
out of standby.
Press the source key you want to use for the
product; for example TV.
Hold down 0 and Mute simultaneously until the
indicator flashes twice and then stays lit.
Enter one of the following codes using the numeric
keypad to indicate the type of product you want to
control.
The indicator should flash once each time you press
•
•
•
•