User guide

12
Troubleshooting
Troubleshooting
The indicator flashes twice after pressing any key
The battery level is low. Replace the batteries as soon
as possible for a new set of four AA type batteries;
see Installing the batteries , page 2.
The LED indicator flashes six times when
attempting to program the MSR+
This indicates that the current operation you are
performing was unsuccessful. For more information
read the instructions for the appropriate programming
procedure.
When I press the source key for one of my
other products, my Meridian controller selects a
different source
Hold down Function while pressing the source key.
This changes the MSR+ to the correct device for
your other product without transmitting the source
command to the Meridian system.
How do I control my television sound and power?
The volume A and V, Mute, and OFF keys are
dedicated to controlling the Meridian system even
when the source key is programmed for another
manufacturer’s product. To control the television
volume or power hold down Function when using
the volume or OFF keys.
I can’t change the television volume after
changing the Meridian volume
You control the volume of another product with the
Function volume keys. To send a Function key
combination immediately after the ordinary key you
need to release and press the key again.
I can’t find the manufacturer of my product in the
device code list
Try auto-programming; see Auto-programming , page 6.
If this fails try learning commands from your product’s
remote control; see Learning commands , page 8.
Commands do not work reliably with my product
Try dual-signal learning; see To Learn dual signals ,
page 9.
I can’t learn successfully from my product’s
remote control
If none of the programming methods succeed it may
be that you have one of a small number of products
that uses non-standard remote control signals not
supported by the MSR+.
The indicator does not light up when I press a key
Try removing and refitting the batteries. If this does
not work replace the batteries with new ones; see
Installing the batteries , page 2.