User guide

9
Programming
Press and release the key on the MSR+ that you
want to use for a particular command.
The indicator will light up to show that the MSR+ is
waiting to receive the code for that command.
Press and hold down the corresponding key on the
product’s remote control to transmit the command.
When the command has been received and learnt
correctly the indicator will flash twice and turn off.
If there was a problem learning the command the
indicator will flash six times.
Press the MSR+ key followed by the product’s
remote control key to learn each of the command
keys you want to use.
When you have finished learning commands from the
third-party remote control:
Press the source key again, eg TV.
The LED indicator will flash once and go off.
Alternatively if you leave the MSR+ without pressing
a key for more than 20 seconds the LED indicator
will flash six times and the MSR+ exits from learning
mode, remembering any keys you have programmed
up to that point.
•
•
•
•
To learn dual signals
Some manufacturers use a sequence of two different
remote control signals to operate their equipment.
To learn the commands for these manufacturers you
need to program each key twice so the MSR+ can
store each of the two signals used for the command.
Program the key using the standard procedure
described above until the indicator flashes twice
and turns off indicating that the first code has been
learnt correctly.
Press and release the same key on the MSR+
again so the indicator lights up again.
Press and hold the same key on the product’s
remote control until the indicator flashes twice and
turns off.
Both signals have now been learnt successfully and
assigned to the MSR+ key.
Repeat the dual-learning procedure for any other
keys you want to program.
Press the source key again to store the settings.
•
•
•
•
•