User guide

Programming

Learning commands

The third and most flexible way of programming the

MSR+ is to learn from your product’s own remote

control. This allows you to control products not

supported by the device library, and gives you the

flexibility to assign any command to a chosen key.

The MSR+ can learn up to 120 commands. If you try

to program more than this the indicator will flash six

times and the MSR+ exits from learning mode.

You can also use learning to add commands additional

to those provided by the device library. Select the

device code first, then learn the additional commands.

Note: You cannot program the dedicated Meridian

keys; see

Dedicated (punch through) Meridian keys

page 5. Also, you cannot learn commands if the

battery level is low. In these cases the indicator will

flash six times when you try to enter the learning

code.

To learn commands

Press the source key you want to use for the

product; for example, TV.

Hold down 0 and Mute simultaneously for two

seconds until the indicator flashes twice and stays

lit.

Enter the learning code 0000 on the numeric

keypad.

The indicator will flash twice and go off. The MSR+ is

then ready to learn commands.

Aim the product’s remote control at the front of the

MSR+, at a distance of 5 to 8cm (2 to 3"):

5-8cm

(2-3")

•