Owner`s manual

19
AUXILIARY OPERATION
ALARM OPERATION
A. Monitor Alarm Circuit
B. Alarm Connection There are two ways to connect with alarm. One is to connect with terminal
Block on the back panel of monitor and the other is with AUX port on rear panel of camera.
B-a. Terminal Block Connection
1. SW IN -GND : This is the COMMON Ground for ALARM OUT & IN.
-VTI : This is the Trigger Input from the Time Lapse VCR for changing the channel
for multiplexing recording.
2. ALARM OUT -HOT/COLD : This is the ALARM OUT for the Time Lapse VCR or ALARM system.
(This terminal is normally open)
If the alarm is occured, this terminal is switched to closed. ("ACTIVE MAKE")
3. ALARM IN -CH1~CH4 : These terminals are assigned to each camera alarm sensor or the special
alarm system.
The alarm sensor must be normally open type.
ALARM SYSTEM
or
SENSOR 1
SENSOR 2
SENSOR 3
SENSOR 4
MONITOR ALARM CIRCUIT
ALARM DEVICE INSTALLATION (In case of using TIME LAPSE VCR)