Specifications

HEATERASSEMBLY
1. After removing the heater from its carton, carefully inspect it for
possible shipping damage. Return damaged units to point of
purchase.
2. Remove one plastic support leg and thermostat knob from
packaging in bottom of heater. The right hand support leg is
pre-assembled to the power cord and requires only to be slid
into place as shown in Figure 1.
3. Fit left hand support leg onto heater and snap into position as
shown in Figure 1.
4. Position thermostat knob onto thermostat shaft as shown in Fig-
ure 1.
NOTE: The knob will only fit onto shaft in one way.
HEATER OPERATION
(Model LFP6152)
1. Your heater is provided with an on/off switch, power on pilot
light (in switch), low and high output pilot lights, and a “smart-
stat” temperature control thermostat.
2. To operate your heater simply:
a. Plug heater power supply cord into 120 volt outlet (see warn-
ings 1, 2, 4, and 7).
b. Push on/off switch to on position. NOTE: The power on
pilot light in switch will be on.
c. Rotate smartstat thermostat knob in a clockwise direction
until it stops.
3. Allow the heater to operate normally until the room tempera-
ture is comfortable to you. Then simply rotate the smartstat
knob counterclockwise until both the red and amber pilot lights
go out. The smartstat thermostat will automatically turn on low
or high heat as needed to maintain the desired room tempera-
ture.
SPECIAL NOTE: Due to the automatic feature of the smartstat,
the heater will operate on the low heat output setting unless there
is a need for more heat (such as during colder winter weather). If
additional heat is needed, the smartstat will turn on the high heat
output. On low heat output, the amber pilot light will be on. When
the smartstat energizes high heat output, the red pilot light will also
come on. This feature saves you money by using only the amount
of electricity needed to maintain the desired comfort level.
NOTE: You may notice a new smell coming from your heater
during initial use. It should go away within the first few hours
of operation. You may also notice it does not heat up imme-
d
iately. Because of the special tubular element design, it
takes a few minutes before you can feel the warmth through
the cabinet.
Cleaning Instructions
(See Warning Number 8)
1. From time to time, your heater will require cleaning to remove
dust and dirt from the element fins and outlet air grille. Maintain-
ing a clean heater will not only help the heater operate effi-
ciently but will allow the heater to operate cooler and thus safer.
2. Always turn power switch off and unplug heater before clean-
ing.
3. Using vacuum cleaner with brush attachment, carefully remove
all dust and dirt from element fins and outlet air grille.
NOTE: Use care when cleaning fins so as not to bend the fins.
4. To clean painted heater surfaces, use damp cloth only. Do not
use waxes, etc. because these sometimes discolor due to tem-
perature.
2
T
HERMOSTAT KNOB
SUPPORT LEGS
Figure 1