User manual

-9 -
Getting Started
Top panel controls
1 Connect the aerial or input source to the appropriate input socket at the rear of the set.
(see page 8).
2 Connect the small round plug on the power adaptor cable to the power input socket at
the rear of the set.
3 Connect the mains cable between the power adaptor and the mains supply
4 Switch the power on, by pressing the POWER button on the front panel or the remote
control, the LED will show green.
5 Use the TV/AV button on the front panel or the remote control to select which input
source to use TV, SCART, AV, S-VIDEO, PC-RGB, HDMI, DVD, DVB.
You can use the front panel controls to adjust the volume or select a channel, as shown
above, or you can use the remote control (see page 10).
6 To switch the set off for a short time, press the POWER button, the set will go into
Standby and the LED will show red. If you are not going to use the set for some
time, switch the power off completely by unplugging the mains cable.