User Manual
INSTALLATION & OPERATION MANUAL 14-0302 REV 4 (11/22)
PAGE
9
OF 16
The function of the buzzer is to signify to the operator that the cycle of cooking has been terminated. The buzzer is
mounted on a bracket which is positioned at the front of the unit just under the front removable panel. The buzzer
electrical circuit is controlled by the timer. When the timer reaches zero the circuit will be completed and the buzzer will
The pilot light is located at the lower right front of the panel. This unit is wired to operate when the heating elements are
The timer, located at the lower right front of the Steam-It provides a means of manual control. The Steam-It put into
an automatic cycle of cooking with the setting of the timer to any of its calibrated periods of cooking. Its timing cycle
however, is automatically delayed by the timer control switch until free-venting has occurred and a cylinder pressure
build up to 10 PSI has been reached.
gauge registers the pressure within the Steam-It cooking chamber. To replace this unit it is necessary to disconnect the
3/16” copper tube connector and remove the two nuts holding the gauge framework in place.
Figure 2
Figure 3