User Manual
INSTALLATION & OPERATION MANUAL 14-0302 REV 4 (11/22)
PAGE
14
OF 16
WARNING
Do not hose down unit as it contains electrical components.
The Market Forge Steam-it Must be cleaned every day as follows:
Daily
and dry thoroughly.
2. Wash interior of Steam-It thoroughly with mild detergent and water (A).
Rinse and dry thoroughly. Cylinder is aluminum and can pit if not cleaned
properly. Be sure to wash drain plug area if you model is so equipped (B).
Weekly
1. Remove door. (Follow these instructions carefully as the clearances
through the portal are close and much confusion can result if not removed
in the sequence described below).
2. Raise the door to a fully open position and disengage the door spring from
each of the door spring studs. Do this by counter-acting the force of the
the door assembly with the free hand. Do this on both sides of the door
assembly.
3. When the ends of the door spring have been completely freed from their
respective door spring studs, the door lift springs on either side of the door
Figure 5
Figure 6
Figure 7