Instruction Manual
INSTALLATION & OPERATION MANUAL 14-0268 REV 9 (07/22)
PAGE
12
OF 20
SIRIUS II -
OPERATION
Electrical Connection: Make sure unit is plugged into a proper receptacle or wired properly and the breaker for the circuit is on.
Water Connection: Make sure the steamer is properly connected to a water source. Do not connect the unit to de-ionized
Gas Connection: Make sure the unit is properly connected to the gas supply line and that all gas valves prior to the unit
are open.
door opening.
Automatic Waterll
and manually drained.
Clean Probe Indicator
shut down the burners until the fault has been cleared. Most commonly, this requires cleaning the water sensor probes.
CAUTION
to a hot, dry reservoir.
Condensate Trough: The trough under the door catches water dripping from the door and exits the steamer at the rear.
Power On / Heat Up: Make sure the door is closed then turn the cooking mode selector to the desired temperature setting
not light, contact your local service agent or the factory.
NOTICE
The burner can be seen from the underside of the steamer.
WARNING
and contact your gas company and service agent.
WARNING
Do not attempt operation of this unit during a power failure.
WARNING