Specifications

5
OPERATION
Operating Instructions
1. Ensure that the external electrical service to kettle is
on.
2. Check pressure gauge for correct cold kettle reading.
Reading should be in the green vacuum zone (25 - 30
In. Hg or 84 - 100 kPa of vacuum). If reading is not
low enough, follow VENTING INSTRUCTIONS prior
to using kettle.
3. Place power switch in ON position.
4. Preheat kettle by placing thermostat knob at ‘10’.
Wait until TEMPERATURE light goes off.
NOTE: Preheatingshouldnotbeusedwhencooking
milkandeggfoodproductswhichadhereto
hotcookingsurfaces.Thesefoodsshouldbe
placedintoacoldkettle.
5. Add food to be cooked into kettle.
6. Place thermostat knob at required temperature set-
ting from 1 to 10 coinciding with a temperature range
indicated by the table on the next page.
Approximate cooking temperatures with water at vari-
ous thermostat settings are as follows:
THERMOSTAT
SETTING
APPROXIMATE (JACKET)
TEMPERATURE
°F °C
1 140° 60°
2 155° 68°
3 172° 78°
4 187° 86°
5 205° 96°
6 223° 106°
7 240° 116°
8 255° 124°
9 271° 133°
10 285° 140°
7. When cooking is nished, set thermostat knob and
power switch to OFF position.
8. Pour nished product from kettle using tilt handle. Be
careful to avoid splashing.
9. Add water to kettle for cleaning purposes.
10. Wash kettle thoroughly. See CLEANING INSTRUC-
TIONS.
TILTING INSTRUCTIONS
Your kettle has a standard “Clean Lock” feature and may
not be tilted without disengaging the tilt knob located on
the console at the top right. This feature locks the kettle
in the upright position and also allows the operator to lock
the kettle at 105 degrees for ease of cleaning. To tilt the
kettle the full distance, the tilt lock knob must be disen-
gaged from the cleaning position by pulling out the tilt lock
knob and tilting the kettle forward the full distance. Follow
these steps to tilt kettle:
1. Pull out the tilt knob at top right located on console.
2. Using kettle tilt handle pull kettle forward to desired
angle of pour or until kettle locks at 105 degrees. The
tilt knob can be released after the kettle has been
tilted approximately 10°.
3. Kettle will lock in position at 105 degrees and may be
tilted further by pulling the tilt lock knob a second time
allowing the kettle to tilt the full distance.
4. To return the kettle to the upright position, pull out the
tilt lock knob and tilt the kettle upward until it locks in
the upright position. The kettle should not move in
either direction once in the upright position.