Specifications

ManualsBrandsMarket Forge Industries ManualsKettleFT-20CE

FT-20CE

ELECTRIC FLOOR MODEL TILTING KETTLES

INSTALLATION - OPERATION - MAINTENANCE

44 Lakeside Avenue, Burlington, Vermont 05401 USA

Telephone: (802) 658-6600 Fax: (802) 864-0183

www.mi.com PN 14-0352 Rev A (9/14)

Summary of content (8 pages)

PAGE 1
FT-20CE ELECTRIC FLOOR MODEL TILTING KETTLES INSTALLATION - OPERATION - MAINTENANCE 44 Lakeside Avenue, Burlington, Vermont 05401 USA Telephone: (802) 658-6600 Fax: (802) 864-0183 www.mfii.com PN 14-0352 Rev A (9/14) © 2014 - Market Forge Industries Inc.
PAGE 2
Your Service Agency’s Address: Model Serial number Oven installed by Installation checked by
PAGE 3
TABLE OF CONTENTS IMPORTANT WARNING: Improper installation, adjustment, alternation, service or maintenance can cause property damage, injury or death. Read the installation, operation and maintenance instructions thoroughly before installing or servicing this equipment. FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance.
PAGE 4
Introduction DESCRIPTION 3. Thermostat control closes to energize contactor coils. Model FT-20CE (20 gallon capacity) is an electrically powered, self-contained, tilting kettle. The appliance has a jacket of double-wall construction forming a sealed reservoir around the lower two-thirds of the kettle. The reservoir is charged with distilled water.
PAGE 5
Service Connections ELECTRICAL CHARACTERISTICS MODEL pH FT-20CE 208V 230V 240V 380V 415V 480V kW Amp kW Amp kW Amp kW Amp kW Amp kW Amp 1 12 33.4 12 30.1 12 28.9 12 18.3 12 16.7 12 14.5 3 12 57.6 12 52.2 12 50.0 - - - - - - SERVICE CONNECTIONS EC Electrical Connection - to be as specified on data plate. ELECTRICAL CONNECTION EC RELIEF VALVE DIMENSIONS ARE IN INCHES [MM] 4 [102] FLANGED FOOT DETAIL 12.
PAGE 6
Installation Instructions 1. Select a location to provide drainage directly below the pour path of the kettle. Position appliance to allow sufficient rear clearance from wall to tilt freely and completely without obstruction. 2. Mark hole locations through flanged adjustable feet. Remove kettle. 3. On hole locations marked, drill holes and insert expansion shields to accommodate 5/16” size lag bolts. 4. Reposition kettle. Level kettle by making necessary adjustments on flanged feet. 5.
PAGE 7
Operating Instructions TILTING INSTRUCTIONS 1. Ensure that the external electrical service to kettle is on. Your kettle has a standard “Clean Lock” feature and may not be tilted without disengaging the tilt knob located on the console at the top right. This feature locks the kettle in the upright position and also allows the operator to lock the kettle at 105 degrees for ease of cleaning.
PAGE 8
Cleaning clear water. Dry the surface completely and allow one hour before using the appliance to cook. WARNING Disconnect the power supply to the appliance before cleaning or servicing. Following daily and period maintenance procedures will prolong the life for your equipment. Climatic conditions salt air - may require more thorough and frequent cleaning or the life of the equipment could be adversely affected.