Service manual

SEPTEMBER 23, 2014 3 4200 & 4292 HALF SIZE ELECTRIC OVENS
REVERSING THE DOOR SWING
1. Remove door handle, P/N 08-5205, by removing
three slotted screws located on edge of handle.
2. Loosen two upper hinge pin screws. Pin will drop into
door.
3. Remove door by tilting top of door outward while lift-
ing door off of lower hinge pin.
4. Remove catch plate assembly from face of oven.
5. Remove four round head machine screws from op-
posite side of oven face.
6. Re-install on other side of oven face, the four round
head machine screws removed in step 5.
7. Re-locate and install catch plate assembly at new lo-
cation.
8. Hold door in new position and allow hinge pin to slide
out. Tighten two screws to hold pin in this position.
9. Release the (new) top hinge pin and re-install door in
the new position. Push up hinge pin and tighten two
screws to hold upper hinge pin in place.
10. Replace handle using hardware removed in step 1.
11. Adjust door by resetting adjustment on catch plate
assembly.