Owner`s manual

18
ILLUSTRATED PARTS LIST
INSIDE OVEN COMPARTMENT
PART NO. DESCRIPTION
99-5027 BAFFLE
99-5057 RACK SUPPORTS
99-5056 RACKS
99-5052 EXTERIOR TOP PANEL
99-5058 EXTERIOR REAR PANEL
99-5020 RIGHT SIDE ACCESS PANEL
99-5035 LEFT SIDE PANEL
10-0633 4” ADJUSTABLE LEGS
99-6176 28” HIGH STAND
99-6177 18” STACKED KIT WITH STAND
4200/4292 REVERSING SWING OF DOOR (S):
Remove door handle, P/N 08-5205, by removing three slotted screws located on
edge of handle.
Loosen two upper hinge pin screws. Pin will drop into door.
Remove door by tilting top of door outward while lifting door off of lower hinge pin.
Remove catch plate assembly from face of oven.
Remove four round head machine screws from opposite side of oven face.
Re-install on other side of oven face, the four round head machine screws removed
in step 5.
Re-locate and install catch plate assembly at new location.
Hold door in new position and allow hinge pin to slide out. Tighten two screws to
hold pin in this position.
Release the (new) top hinge pin and re-install door in the new position. Push up
hinge pin and tighten two screws to hold upper hinge pin in place.
Replace handle using hardware removed in step 1.
Adjust door by resetting adjustment on catch plate assembly.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.