Operating instructions

FIG. 7.10

UNIVERSE SKILLET OPTIONS, INSTRUCTIONS TRIM JOINING KIT

5. Thread Item 1 (Refer to Drawing 98-1517 3/8-16 Threaded Bolt thru Riv-nut on the lower left side of

the skillet so that there is enough room to secure Washer (Item 3)and Nut (Item 2) on the inside of

the skillet. Refer to figure 1.2. Secure Threaded Bolt (Item 1)into place using Washer (Item 3) and

Nut (Item 2) hand tighten washer and nut into place. Repeat this procedure for all upper

mounting holes. (4 places)

6. Use additional Washers (Item 2) and Nuts (Item 3) provided with kit to adjust and use as spacers

where needed during assembly.

7. If feasible at this time align skillet with adjoining unit. Threaded Bolt (Item 1) should slide thru

mounting location provided on al lGF Market Forge modular assembly frames. Attach using

Washers (Item 3) and Nuts (Item 2) to inside of adjoining unit. Hand tighten washer and nut into

place. Repeat this procedure for all lower mounting holes. (4 places) (See Fig 1.2)

Figure 1.2

CROSS SECTION OF MOUNTING LOCATION

ITEM#

MF PART NO.

DESCRIPTION

QTY

0969

3/8

THREADED ROD

10-2317

3/8-16 HEX NUT

10-2401

3/8 WASHER, S.S

8. After all eight Threaded Rods (Item 1) have been hand tightened, reinstall all modular frame

enhancements provided with the Universe Skillet.

9. Tighten and secure all nuts.

10. Refer to Installation & Operating Instructions before using unit.

7-17