Operating instructions

FIG. 7.6-8 UNIVERSE SKILLET OPTIONS, INSTRUCTIONS CASTERS & STRAIN RELIEF
INSTALLATION INSTRUCTIONS FOR CASTERS
ON THE UNIVERSE SKILLET
WARNING: Before raising skillet base make sure the pan is in the down position for steps 1-8.
1. Raise the front of the skillet base and brace with front of skillet off the ground.
2. Insert casters with brakes into the front legs of the frame
NOTE: Casters must screw fully into the frame of the skillet in order for them to be able to be
tightened.
3. Tighten the nut at the base of the casters until casters are securely fastened into the legs of the frame.
4. Put the universe skillet down on the floor.
5. Apply the brakes in the front by stepping on the lever on the side of the front casters until it is in the on
position.
6. Raise the rear of the skillet base and brace with rear of skillet off the ground.
7. Insert casters without brakes into the rear legs of the frame
NOTE: Casters must screw fully into the frame of the skillet in order for them to be able to be
tightened.
8. Tighten the nut at the base of the casters until casters are securely fastened into the legs of the frame.
9. Put the Universe Skillet down on the floor.
NOTE: For units with Gas Strain Relief Kit (MF# 98-1421) refer to # 10.
10. Refer to the Installation Instruction provided with the Gas Strain Relief Kit (MF #98-1421) for
recommended mounting instructions for the complete Gas Strain Relief Quick-Disconnect kit.
NOTE: See figure for recommended location of l-bolt. (MF #08-7839)