Operating instructions

6. Remove control box cover by removing screw in rear
and right side of cover.
7. Locate temperature control circuit board (see Figure
6.1)
and calibrate as follows:
a. If temperature goes above 375°F (191°C), turn
setpot labeled HI counterclockwise to decrease
temperature.
b. If temperature goes below 375°F (191°C), turn
setpot labeled HI clockwise to increase temperature.
NOTE: Turn the HI setpot only. Be careful when turning
setpot—just a slight turn (approximately 22°) will
change temperature by 25°F.
8. Allow skillet to cycle three (3) times. This cycling allows
temperature control to stabilize.
9. Record thermometer reading when pilot light goes out. If
a temperature of 370°-380°F (188°-193°C) is recorded,
calibration procedure is complete. If not, repeat steps 7
and 8 until appropriate temperature is recorded.
10. Replace control box cover by pushing down and
replacing screw in rear and right side of cover.
FIG. 6.1
TEMPERATURE CONTROL CIRCUIT BOARD
REPLACEMENT OF TEMPERATURE CONTROL
1. Place circuit breaker in OFF position.
2. Remove skirted dial knob by pulling it off the control box
cover.
3. Remove control box cover by removing screw in rear and
right side of cover.
4. Disconnect all wire leads from temperature control.
NOTE: Leads should be marked appropriately to facilitate
re-installation.
5. Remove temperature control by removing two (2) pan
head nuts from side of control box.
6. Install new temperature control and reverse steps 1-5.
ADJUSTMENT OF INTERLOCK SWITCH
1. Tilt skillet pan all the way in the downright position.
NOTE: If adjusting the interlock switches for the tilt
mechanism in a power tilt unit, the pan will have
to be all the way in the upright position to adjust
one of the switches.
2. Place circuit breaker in OFF position.
3. Open the nema box by loosening the two screws at the
top of the nema box.
4. Loosen the bottom nut of the switch until it contacts with
the cam and depresses the plunger on the switch.
5. Tighten the top nut on the switch to keep the switch in
the desired location.
6. Close and fasten the nema box by tightening the 2
screw:
at the top of the box.
7. Place circuit breaker in ON position.
6-2