Owner`s manual

TABLE OF CONTENTS

INTRODUCTION

NOTICE:

THE FOLLOWING FAUCETS ARE THE ONLY ONES APPROVED BY THE MASSACHUSETTS

BOARD OF REGISTRATION OF PLUMBERS AND GAS FITTERS FOR INSTALLATION ON

THIS EQUIPMENT.

SINGLE PANTRY FAUCET MANUFACTURED BY T & S BRASS AND BRONZE WORKS, INC.

MODEL # B-0305 OR CONCEALED MIXING FAUCET WITH 4-ARM HANDLES MANUFAC-

TURED BY T & S BRASS AND BRONZE WORKS, INC. MODEL # B-0512.

IMPORTANT:

INSTALLING, OPERATING AND SERVICE PERSONNEL:

INSTALLATION OF THE EQUIPMENT SHOULD BE PERFORMED BY QUALIFIED, CERTIFIED, LICENSED

AND/OR AUTHORIZED PERSONNEL WHO ARE FAMILIAR WITH AND EXPERIENCED IN STATE/LOCAL

INSTALLATION CODES.

OPERATION OF THE EQUIPMENT SHOULD BE PERFORMED BY QUALIFIED OR AUTHORIZED PERSON-

NEL WHO HAVE READ THIS MANUAL AND ARE FAMILIAR WITH THE FUNCTIONS OF THE EQUIPMENT.

SERVICE OF THE EQUIPMENT SHOULD BE PERFORMED BY AN AUTHORIZED MARKET FORGE SERVICE

AGENT.

SHIPPING DAMAGE CLAIM PROCEDURE:

THE EQUIPMENT IS INSPECTED & CRAFTED CAREFULLY BY SKILLED PERSONNEL BEFORE LEAVING THE

FACTORY. THE TRANSPORTATION COMPANY ASSUMES FULL RESPONSIBILITY FOR SAFE DELIVERY UPON

ACCEPTANCE OF THIS EQUIPMENT.

IF SHIPMENT ARRIVES DAMAGED:

VISIBLE LOSS OR DAMAGE: NOTE ON FREIGHT BILL OR EXPRESS DELIVERY AND HAVE SIGNED BY

THE PERSON MAKING DELIVERY.

FILE CLAIM OR DAMAGES IMMEDIATELY REGARDLESS OF THE EXTENT OF DAMAGES.

CONCEALED LOSS OR DAMAGE: IF DAMAGE IS NOTICED AFTER UNPACKING, NOTIFY THE TRANSPOR-

TATION COMPANY IMMEDIATELY AND FILE ‘CONCEALED DAMAGE’ CLAIM WITH THEM.THIS SHOULD

BE DONE WITHIN FIFTEEN DAYS FROM THE DATE DELIVERY IS MADE TO YOU. RETAIN CONTAINER FOR

INSPECTION. IDENTIFY IMMEDIATELY

•

SPEC SHEET INFORMATION ...................................

INSTALLATION ...........................................................

OPERATION ...............................................................

TEST KITCHEN BULLETIN ........................................

TROUBLE-SHOOTING ...............................................

MAINTENANCE ..........................................................

WIRING .......................................................................

PARTS ........................................................................

10-18