Owner`s manual

TROUBLE-SHOOTING
8
REPLACEMENT OF TEMPERATURE CONTROL:
1. Place circuit breaker in off position.
2. Remove skirted dial knob by loosening two set screws in
the knob. (Use a 5/64 Hex key to loosen screws).
3. Tilt control box up by rst removing two pan head screws in
the lower front of the console. Use the prop up arm located
inside, in the rear vertical column, to keep the console cover
tilted open.
4. Disconnect all wire leads from temperature control.
NOTE: Leads should be marked appropriately to facili-
tate re-installation.
5. Remove temperature control by removing two (2) pan head
screws from side of control box.
6. Install new temperature control and reverse steps 1 - 5.
ADJUSTMENT OF INTERLOCK SWITCH:
1.Tilt skillet pan all the way in the downright position.
2.Place circuit breaker in off position.
3. Tilt control box up by rst removing two pan head screws in
the lower front of the console. Use the prop arm located in-
side, in the rear vertical column, to keep the console cover
tilted open.
4. To reduce the angle where the switch disengages when the
pan is tilted, use a pair of heavy duty needle nose pliers
and lightly bend the tilt tab on the trunnion up. To increase
the angle, bend the tilt-tab down. Test by tilting the pan and
checking at what angle the switch clicks. The switch should
click off at approximately 10° tilt of the pan from the horizon-
tal position.
5. Close and fasten the control console by tightening the two
screws at the lower front of the box.
6. Place circuit breaker in on position.
PROBLEM
Uneven or poor heating. a. Temperature control out of a. Replace temperature control.
calibration or defective.
b. Unit attached to wrong gas supply. b. Compare to specifications
on data plate.
c. Combination gas control set to c. Adjust manifold pressure to
wrong pressure. equal that listed on data plate.
Signal light out. a. Burnt out bulb. a. Replace.
b. Broken temperature control. b. Replace.
c. Loose electrical connection. c. Repair.
Unit fails to heat. a. Ciruit breaker is off. a. Reset ciruit breaker.
b. Malfunction of interlock switch. b. Adjust or replace.
c. Broken ignition module c. Replace.
d. Broken ignitor/sensor. d. Replace.
No 110 Volts output. a. Defective temperature control. a. Replace.
b. Broken temperature sensor. b. Replace.
No gas to unit. a. Defective gas valve. a. Replace.
PROBABLE CAUSE REMEDY
TROUBLE-SHOOTING GUIDE
MAINTENANCE
DAILY CLEANING:
1. The skillet should be cleaned daily.
2. Wash the skillet with a mild detergent and hot water. If food is stuck to the surface of the skillet pan, soak it and use a
little heat or loosen the food. Then, wash with clean water and dry.
3. Be sure to wash under the skillet cover and rinse with clean water.
4. Check the skillet pouring lip corners to be sure they are clean. Also, wash around the exterior of the skillet. Rinse with
clean water and air dry.