Operating instructions

POWER SAVER II ELECTRIC CONVECTION OVEN

2. Seat wire shelf supports in mounting locations

inside oven, and slide shelves into position with

raised 'stop' edge at rear.

NOTE

Make sure wire shelf supports are in, not on,

brackets

3. With a level on the oven shelves, make sure the

oven is level both front and back, left and right To

adjust, turn feet in stand legs.

4. Make sure power supply is available to the oven

5. Set thermostat dial at 350°F.

6. Place power switch in the ON position with doors

open

7. Close doors. Indicator light should come on;

fan should come on and rotate clockwise

(seen from front). If not, see Table 5-1.

8. Indicator light will remain on while oven is heating,

and go out when preset temperature is reached.

During the heat-up period, some slight smoke or

fumes may be produced by oil or grease on metal

surfaces. This should cease after five minutes.

9. After this check is completed, turn thermostat dial

and power switch to the OFF position.

2.4.2 Shut-Down Procedure

1. For daily shut-down, place thermostat dial and

power switch in OFF position.

2. For extended shut-down, place thermostat dial and

power switch in OFF position. Leave doors ajar.

170393