Operating instructions

MAINTENANCE 6-3
6.4.3.2 Fan Motor Removal
Motor removal is completed from inside the oven
With external circuit breaker shut off, proceed as
follows 1 Remove deflector and fan guard (Figure 7-
1, 18,17)
2. Remove four nuts (20) and clips (19, 21 and 23)
from motor assembly.
3. Pull motor forward. Carefully disconnect electrical
wiring.
4. Slide motor off screws. Identify and tag wires.
5. Install replacement motor assembly as required
6.4.4 Heating Element Removal
6.4.4.1 Rear Heating Element Removal
Removal of rear heating elements (Figure 7-3, 1)
is completed from inside the oven. With external
circuit breaker shut off, proceed as follows:
1. Remove oven shelves, shelf supports, (Figure 7-1,
12) deflector (18) and fan guard (1 7).
2. Remove screw from heating element bracket at
top right rear of oven liner.
3. Lift element up and off retaining brackets (Figure
7-3, 3).
4. Gently pull bracketed end of element away from
oven liner. Remove terminal screws from
elements and tag wires for identification.
5. Replace with new element as required, proceeding
in reverse sequence of above.
6.4.4.2 Bottom Heating Element Removal
Removal of bottom heating elements is completed
from the front of the oven. With external circuit
breaker shut off, proceed as follows:
1. Lower hinged bottom front panel of oven, (Figure
7-2, 34).
2. Remove wing nut (Fig. 7-3, 12) and washer (10)
from underside of retaining panel (9).
3. Remove screws (11) from front of retaining panel,
and lower panel.
4. Remove screws (4) from heating element brackets.
5. Gently slide element (2) out. Remove terminal
screws from elements and tag wires for
identification.
6. Replace with new element as required, proceeding
in reverse sequence of above.
6.4.5 Thermostat Removal
1. Remove screws (Figure 7-1, 22) from control panel
(14).
2. Remove five screws that secure perforated
capillary tube guard (9) to oven liner.
3. Slide thermostat bulb out from clips (19 & 21) and
thread capillary tube through hole leading to the
control area.
4. Remove thermostat control (Fig. 7-4, 4) from
control panel.
5. Slide entire assembly out front of oven through the
control area.
6. Install replacement thermostat as required.
17-0393