Product Info
10106923-AA 5
English
The printer must always be disconnected from the
mains by the mains plug before any operations
Use appropriate tools for any work on the electrical
and hydraulic circuits.
When working on the ink circuit, immediately wipe
off any spillage and visually check for leaks.
After each maintenance operation, the waste
recepticles used should be emptied and cleaned.
Do not leave rags soaked with consumables near
the printer.
This unit contains a non-replaceable internal lithium
ion battery. The battery may burst or explode,
releasing hazardous chemicals. To reduce the risk
of fire or burns, do not crush, puncture, or dispose
of the battery in fire or water.
■ Recycling
Disposal of used batteries and re-
chargeable batteries (applicable in
waste collection systems).
Disposal of used electrical and
waste collection systems).
These symbols indicate that the electrical
and electronic device, and the batteries and
rechargeable batteries therein, must not be
disposed of at the end of its life as ordinary
municipal solid waste. By ensuring that these
items are disposed of appropriately, you play an
that incorrect disposal could have on the
environment and human health. The recycling of
materials contributes to the preservation of natural
resources.
By entrusting your end-of-life electrical devices to
a duly authorized disposal company, you ensure
that all the items therein will be handled correctly.
In all other cases and in order to safely remove
batteries, rechargeable batteries and other
materials, see the user manual or contact your
Markem-Imaje representative.
■ Waste consumables
The Consumable waste must be managed in
compliance with local regulations related to waste
management and dangerous goods transport.
Transport, transit, treatment of consumable waste
must be operated by entity owning appropriate
waste management licences.
Consumable waste must be treated in compliance
with local regulations either by recycling solution
(e.g distillation), incineration with energy recovery,
incineration or specific land filling.
■ Radio
An RFID tag is fitted to each ink cartridge and
contains the set-up information of the cartridge as
The printer reads the RFID tag during the
calibration process and ‘pairs’ with the cartridge.
maximum power limit of 10mW from the antenna.
■ FCC Rules
Caution: Changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s authority to operate the
to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
is operated in a commercial environment. This
accordance with the instruction manual, may cause
harmful interference to radio communications.
likely to cause harmful interference in which case
at his own expense.
Canada, Industry Canada (IC) Notices
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for
the transmitter by Industry Canada.
To reduce potential radio interference to other
users, the antenna type and its gain should be so
power (e.i.r.p.) is not more than that necessary for
successful communication.
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions: this device
may not cause interference and this device must
accept any interference, including interference that
may cause undesired operation of the device.
For Marking & Coding Equipment. Photographs and drawings
are not binding in detail. . This document was originally written in
French. The French text of this document shall alone be authentic