User Manual

06
MARCUS MILLER CMD 101 MICRO 60
1x10” + TWEETER | 60W
This is not just a practice amp, the sound quality delivered by this 60W small combo is really impressive. At Markbass we are unable to make something not sounding sound good, we always use the best components
to achieve a full, round Markbass sound! Great choice for small gigs and recording and, thanks to the balanced output, you can connect it to a mixer/PA, then using it as a small personal monitor. This compact combo
amp section also features level control, 3- band EQ, aux in, headphone out, speaker on/o switch.
TECHNICAL SPECS
PREAMP AMP: SOLID STATE
POWER AMP: ANALOG
CONTROLS: GAIN - MASTER
EQ (±16dB): LOW (40 HZ) | MID (800HZ) | HIGH (6 KHZ)
POWER: 45W RMS@8Ω/60W RMS@4Ω
OTHER FEATURES:
AUX IN
HEADPHONE OUT
XLR LINE OUT
SPEAKER ON/OFF
OUTPUT FOR EXTERNAL CAB (MINIMUM LOAD 8Ω)
SPEAKER SIZE / IMPEDANCE: 1x10” MARKBASS CUSTOM / 8Ω
SPEAKER Power Handling: 200W RMS (AES STANDARD)
FREQUENCY RESPONCE: 45HZ TO 18KHZ
CROSSOVER FREQUENCY: 3.5KHZ
VOLTAGE SELECTOR: This combo feature a 120V/240V Voltage Selector to use the amp in countries with dierent voltages, so make sure the switch on the rear panel is on the correct
voltage before connecting it to the AC power, and the fuse is the right value for that voltage (This selector is not available on the 100V version).
Please change the voltage/fuse values label located near the voltage selector matching the voltage/fuse values when you need to change the voltage of the apparatus.
WEIGHT: 25.35lbs/11,5kg
DIMENSIONS: 14.56”/37cm | 13.14”/33,4cm | 14.40”/36,6cm
FUSES: T 2A 250V for 100V setting;
T 2A 250V for 120V setting;
T 1A 250V for 230V/240V setting;
Minimum ohm load for all Markbass heads/combos is 4 ohms.
Markbass amps/combos are manufactured to be sold and used in the country of purchase, and they are factory preset to that country’s voltage. Due to homologation issues, the voltage may not be changed.
NOTE: Product specications are subject to change without notice.