User Manual

NOTE

CH1 CH2 BOOST

EVO1 CONTROLLER

FX1 FX2

HOLD FOR

MUTE

TUNER

PUSH ACTIVE CH

FOR MIXING

EVO1 CONTROLLER

The optional Markbass EVO CONTROLLER allows to active CH1 / CH2 or MIX both, turn ON/OFF the FX1,

FX2 and BOOST, plus accessing the TUNER with MUTE function pressing and holding the boost switch.

The Markbass EVO 1 MIDI port features 9VDC phantom power (200 mA) via MIDI 5 poles cable (all pins

connected) to power the EVO CONTROLLER (or MIDI Pedalboard compatible with this voltage/power).

The EVO can be controlled also via programmable MIDI pedalboard as for the MIDI commands listed

below:

• TRX MIDI CHANNEL #0

• CH1 Program Change #1

• CH2 Program Change #2

• MIX CH1+CH2 Program Change #3

• FX1 Control Change #1 (ON 1 / OFF 0)

• FX2 Control Change #2 (ON 1 / OFF 0)

• BOOST Control Change #3 (ON 1 / OFF 0)

• TUNER Control Change #28 (ON 1 / OFF 0)

MARKBASS CONTROL SOFTWARE

The Markbass EVO Control software is available for FREE DOWNLOAD at www.markbass.it (for Windows

and MAC) and it allows to customize your Markbass EVO 1 selecting the preferred AMP on each of the

six locations of the two channels and the preferred eect (or none) for each channel and its parameters,

plus the Boost Level.

- DOWNLOAD the Markbass EVO Control software and unzip the le, then install the version compatible

with your computer.

- Connect the USB port on the rear panel of the Markbass EVO 1 to a computer using a USB A/B (printer)

cable, when the unit is communicating with the software the connection LED on the left bottom side

will turn from grey into green.

- To select an AMP in one of the 6 positions of CH1 click on the arrows on its right side and the list of

AMPS will be shown, select the desired one clicking on its name, then press STORE; same procedure

for CH2.

- To select the desired eect for CH1 click on the arrows on EFFECT section and select the preferred

one clicking on its name, set the parameters as for your preference and press STORE; same procedure

for CH2.

- To select the level of BOOST, drag

the virtual knob and set it as for your

preference, then press STORE.

- The FIRMWARE button on the right

bottom side allows to upgrade the

Markbass EVO1 amplier rmware when

new updates are released.