User Manual

08
TECHNICAL SPECS
CHANNELS: Two + MIX mode
INPUT CH1: 1x 1/4” mono jack (impedance 1MΩ)
INPUT CH2: 1x 1/4” mono jack (impedance 1MΩ)
AUX IN: 1x 1/8” stereo jack
USB port: USB type B
2 RETURN INPUTS: 2x 1/4” mono jack (50KΩ)
2 SEND OUTPUTS: 2x 1/4” mono jack (1KΩ)
SPEAKER OUTPUTS: 2x 1/4” mono jack + 1x Speakon parallel wiring, minimum impedance load
4 ohms
LINE OUT 1: 1x XLR male balanced
LINE OUT 2: 1x XLR male balanced
PHONES OUTPUT: 1x 1/8” stereo jack
MIDI IN: DIN 5 poles
CONTROLS (for each channel)
Gain / Low / Mid / High / Level / FX Level
Amps Selection: 6 for CH1 / 6 for CH2
OTHER CONTROLS (commons)
Channel Switch: CH1 / MIX / CH2
MIX: CH1 / CH2
Phones Level, Master, GND Lift switch, Pre/Post MIX switch
MIDI FUNCTIONS
Switch CH1, CH2, MIX
FX1 ON/OFF, FX2 ON/OFF
BOOSTER ON/OFF
MUTE/TUNER
OUTPUT POWER
500W RMS @ 4 ohms / 300W RMS @ 8 ohms (impedance minimum load 4 ohms)
A/D
D/A
DSP
Line
out 1
Phone
s
Speaker
In 2
...
USB
Midi
+
Aux_in
Aux_in
Master
S/R 2
+
Line
out 2
+
Limiter
+
Phones
level
Pre/Post
In 1
S/R 1
Aux_in
+
BLOCK DIAGRAM
OTHER
HEIGHT: 3.94 in. / 100 mm
WIDTH: 14.17 in. / 360 mm
DEPTH: 10.04 in. / 255 mm
WEIGHT: 7.72 lbs / 3,5 kg
POWER REQUIREMENT:100V; 120V; 230V; 240V 50/60Hz
Voltage is factory preset according to region of sale).
Markbass amps/combos are manufactured to be sold and used in the country of
purchase, and are factory preset to that country’s voltage. Due to homologation
issues, the voltage may not be changed.
FUSE:
EUROPE 4 A 250V T 5x20
AUSTRALIA/UK 4 A 250V T 5x20
USA/CANADA 8 A 110V T 5x20
JAPAN 10 A 100V T 5x20
Markbass amps/combos are manufactured to be sold and used in the country of purchase, and they are
factory preset to at country’s voltage.
Due to homologation issues, the voltage may not be changed..