User Manual
07
32/34) SEND/ RETURN 1 If you use eect pedals or rack gear, you can route them through
the CH1 using SEND 1 (32) and RETURN 1 (34), connecting the
SEND to the input of the eect and the RETURN to the eect’s
output using instrument cables.
33/35) SEND/ RETURN 2 If you use eect pedals or rack gear, you can route them through
the CH2 using SEND 2 (33) and RETURN 2 (35), connecting the
SEND to the input of the eect and the RETURN to the eect’s
output using instrument cables.
36) GROUND LIFT Occasionally when you’re playing live and using the LINE OUT,
the soundman will detect a hum from your amp’s signal. This is
almost always due to a grounding problem related to your power
source; you will likely eliminate this hum simply by ipping the
GROUND LIFT switch.
37) PRE MIX / POST MIX This switch determines whether the signals that leave the LINE
OUT XLR outputs are from CH1 to Line Out 1 and CH2 to Line
Out 2 (PRE MIX) or the mix of both channels (POST MIX) to each
output.
38) LINE OUT 1 This output sends the CH1 signal to the mixing console, to
recording device, DI, etc. The Line Out signal is post eect.
39) LINE OUT 2 This output sends the CH2 signal to the mixing console, to
recording device, DI, etc. The Line Out signal is post eect.
The two channels separate LINE OUTs allows to sends the
two signals to the devices for live or studio applications, as well
as to have separate signals from the instruments connected to
the inputs.