User Manual

05
12) AMP 2 Select between six AMPS tone choices available at channel 2.
FACTORY SETTING CH2
• B-Drive21 (TECH 21® SANSAMP ®)
warm, rich, organic natural tone
• Red ‘96 (SWR ® Red Head ®)
tube, super high-delity sound
• Blue ‘70 plus (Ampeg ® SVT-VR ® Blue Line plus)
tube, punch, all-encompassing low-end warmth tone
• Bassface ‘59 US (Fender ® Bassman ®)
vintage, clean and warm, legendary tone
• UK120 (VOX ® AC 120 ®)
vintage, mellow sound
• JMayor (MARSHALL ® MAJOR ®)
vintage, classic rock icona tone
note: You can update AMPs choices for each channel as for your preference thanks to
the MARKBASS EVO SOFTWARE)
13) GAIN This knob sets the gain level of the channel 2.
14) LOW This knob controls the amount of low frequencies of the selected AMP / CH2.
15) MID The Mid control regulates the midrange frequencies of the selected AMP /
CH2.
16) HIGH The High knob controls the amount of high frequencies of the selected AMP /
CH2.
17) LEVEL Controls the level of the selected AMP model on CH2.
18) FX 2 LEVEL Controls the level of the eect of channel 2.
FX FACTORY SETTING CH2: T-CHORUS
note: - You can update FX choices for each channel and customize their parameters as
for your preference thanks to the MARKBASS EVO SOFTWARE.
- FX ON/OFF switching can be controlled by the EVO pedal.
- In MIX mode the eects don’t work simultaneously.
19) MUTE/TUNER The DV Mark/Markbass EVO 1 features an onboard tuner that lets you tune
your instrument at a regular 440Hz tuning, half step down and a whole tone
down. The default status is 440Hz and the light on the “b” will light in green.
Pushing and holding the MUTE/TUNER button, the LED will light in Orange
after releasing it and you can tune your instrument half step down. Pressing
and holding the same button a second time will make the “b” LED light in red,
that means you’re ready to tune your instrument a whole step down. Pressing
and holding again you’ll go back to the 440 Hz tuning mode.
20) MIX This knob allows to mix the CH1 and CH2 when you select MIX mode.
21) BOOST This LED signals when the BOOST is actived, BOOST ON/OFF switching is
controlled by the EVO pedal.
note: You can customize the boost parameter as for your preference thanks to the
MARKBASS EVO SOFTWARE.
22) MASTER This control is the master feed from the end of the channels CH1/CH2 to
the power stage. Start with the Master control OFF (all the way
counter-clockwise) and turn it up gradually until you reach your desidered
volume.
23) PHONES LEVEL Controls the level of the signal send to the PHONES OUTPUT (24).
24) PHONES For quiet practing plug headphones into this mini plug 1/8” input.
25) ON/OFF SWITCH This switch delivers AC power to the amp.
The Markbass EVO 1 is manufactured to be used in the country where it has
been sold, and it’s factory preset to that country’s voltage. So make sure
you’re sending the correct voltage to your amp before you connect it to AC
power and turn on the amp.