Owner's Manual

03
TECHNICAL SPECS
INPUTS
INPUT: 1 Mohm - 5Vp (Jack Mono)
CONTROLS
MASTER VOLUME
LIMITER (from 0 to MAX)
OUTPUTS
SPEAKER OUT: speakon
OTHERS
BI-BAND LIMITER
WEIGHT: 6.04 lbs / 2,74 kg
WIDTH: 10.87”/ 27.6 cm
DEPTH: 9.84”/ 25 cm
HEIGHT: 3.27” / 8.3 cm
OUTPUT POWER: 1000W RMS @ 4 ohms / 600W RMS @ 8 ohms
POWER REQUIREMENT: 100/120V; 230V; 240V - 50/60Hz
(Voltage is factory preset according to region of sale)
WARNING:
The LITTLE MARK VINTAGE AMP 1000 is manufactured to be used in the country where they have been
sold, and they are factory preset to that country’s voltage. So make sure you’re sending the correct voltage
to your amp before you connect it to the AC power. Due to homologation issues, the voltage may not be
changed.
Minimum ohm load for all Markbass heads/ampsis 4 ohms.
NOTE1: Equipment for professional use.
NOTE2: Product specications are subject to change without notice.
FUSES: LITTLE MARK VINTAGE AMP 1000
T 12A 250V for 100V setting;
T 10A 250V for 120V setting;
T 8A 250V for 230V/240V setting
Block Diagram - LITTLE MARK VINTAGE AMP 1000
The LITTLE MARK VINTAGE AMP 1000 is part of our Vintage series lineup, state of the art products that mark a new era at Markbass. This 1000W power amp is warm,
dened and clear even at full volume. With this much power at your disposal, and the new bi-band limiter built in, you can play across a wide dynamic range and even
handle high signal peaks without clipping. It’s a perfect match for the amazing MARK VINTAGE PRE or any other bass preamp. Clear and consistently reliable, while
being ultra-lightweight and super portable.
Input
Buffer
LIMITER
Power
Ampli
Power
Output
Biband