Instruction Manual

slotted side ap
FIG. 1 : Open Base to a square shape.
Turn upside down on oor.
Fold slotted side aps.
Fold in back and front angled aps
into slots of side aps.
A
B
FIG. 2 : Set base upright on oor.
Fold in side panels A.
Fold front step B back
as shown, inserting tabs
into slots in side panels of base.
Tray
FIG. 3 : Remove tray lled with clocks.
Reinforce tray side aps, top aps and
bottom with additional tape.
Set tray on base.
Header
FIG. 4 : Fold side panels of header back as shown.
Insert bottom side aps of header into slots
along top edge of tray, and slide down
until header is ush with top of tray
1 2
3 4
SET UP INSTRUCTIONS