Setup guide

8
Virtual Control Panels
Usage
Context Menu Commands
The context menu presents 3 dialogs, 3 checkbox options, and 4 commands:
When a virtual panel is not connected to a router control system, the ‘Disconnect’ command is
disabled.
When a virtual panel is connected to a router control system, the ‘Set Parameters’, ‘Connect’, and
‘Allow Auto Reconnect’ options are disabled.
Set Parameters...
Use this command to set the IP address of the primary system controller and the panel ID. See
Initial Setup
on page 4 for a discussion.
Change Button Text...
Normally you would never use this command. You might occasionally use this command to
update the button text for your virtual panel. It displays a dialog in which you can browse to
select the appropriate .legends file:
In most case, you will find .legends files in this folder in the NV9000 system controller (and not
on your Macintosh):
C:\NVision\envy\usersys\live\
(A .legends file provides the fixed button text for the panel configuration.)
Before Connection After Connection